Assembly and installation

Assembly and installation

You can also count on us after your purchase. We will come to your site to assemble and fine-tune the system until everything works as planned and in accordance with the applicable standards. The safety inspection will be a mere formality.


Smooth installation of transmitters

No worries about the installation of radio transmitters and overload protection devices, whether it’s a new system or a retrofit. Our technical department will be happy to visit you on-site. You choose a suitable moment on the agenda so that your activities will not be hindered.

Installations are always finished with the addition of the mandatory direction stickers and, if necessary, lamps or signal horns. In the case of more complex remote controls, we will visit you beforehand to draw up an installation plan.

Full commissioning of crane control systems

The installation of complete crane control systems requires the necessary technical knowledge. We come on-site with an experienced technician and an engineer to ensure that everything runs quickly and reliably. They work together with your own technicians so that they also get to know the subtleties of the system. This enables them to carry out maintenance actions themselves at a later stage, possibly with telephone support from our engineers.

Parameter settings, calibration and testing

Our team takes care of the installation and calibration of overload protection devices. You can also leave the calibration of other sensors and the setting of the position parameters to them. Wireless networks are thoroughly tested and antenna locations optimized. In addition, they check all wiring and test the full functionality, so you can be sure that the system is working 100% safely.